Revit MCP guide · Start

Install

Download the installer, run it, and answer the two prompts an unsigned beta build causes.

Download the installer

The installer is on your Revit MCP page, behind a sign-in. It is free to download for any lAvArt account, with or without a trial, and it stays available after a trial ends.

  1. Sign in, or create an account

    Open your Revit MCP page. New here? Create an account: no card, and it takes you straight to that page.
  2. Press Download the installer

    One file covers Revit 2025 and 2027. Windows only, like Revit.

Run the installer

  1. Close Revit

    The installer adds the add-in while Revit is not running.
  2. Run the file you downloaded

    It installs for your Windows user only, so it asks for no admin rights. Windows may stop and warn you first: see the SmartScreen warning below.
  3. Tick the Revit versions to add it to

    It offers the ones it finds on this computer.
  4. Using Claude Desktop? Tick Connect Claude Desktop

    Quit Claude Desktop fully first (right-click its icon in the tray, Quit). This one tick does the whole of Connect Claude for Claude Desktop. Using Claude Code instead? Leave it unticked.
  5. Finish, then start Revit

The Windows SmartScreen warning

The beta installer is not yet signed with a publisher certificate. Windows does not recognise the publisher, so it may show a blue window titled Windows protected your PC.

  1. Choose More info

  2. Choose Run anyway

    The installer then starts as normal.
Placeholder, not a picture: the Windows protected your PC window, with More info and Run anyway.

This warning is about the missing signature, not about anything the file was found to do. If your practice does not allow unsigned software, wait for the signed build: write to info@lavart.ai and we will tell you when it is out.

Revit's Always Load prompt

For the same reason, the first time Revit starts after installing it asks whether to load the add-in, in a window titled Security - Unsigned Add-In.

  1. Choose Always Load

    Revit loads the add-in now and does not ask again.
Placeholder, not a picture: Revit's Security - Unsigned Add-In window, with Always Load.
  • Load Once works too, but Revit asks again next time.
  • Chose Do Not Load by mistake? Close Revit and start it again: it asks again.

Check it loaded

In Revit, look for the lAvArt tab in the ribbon. On it, the lAvArt MCP panel shows a status button, Permission, Pause AI and Activity. Open any project: Permission reads Read only, which is how every document starts.

Placeholder, not a picture: the lAvArt tab in the Revit ribbon, with the lAvArt MCP panel.

No lAvArt tab? See Troubleshooting. Otherwise, next: Connect Claude.

Update or remove it

  • Update: download the newer installer from your Revit MCP page and run it over the old one, with Revit closed. Your permissions and settings are kept.
  • Remove: in Windows, open Settings, Apps, Installed apps, find lAvArt MCP for Revit and choose Uninstall.
What each installer contains is on the Changelog.

Something here wrong, or missing? Write to info@lavart.ai.